Certification Exam Prep Questions For CompTIA Network+ N10-007
QuickStartis now offering assessment questions for CompTIA Network+ N10-007. Whether you are deciding which exam to sign up for, or simply want to practice the materials necessary to complete certification for this course, we have provided a practice assessment to better aid in certification. 100% of the questions are real questions; from a recent version of the test you will take for CompTIA Network+ N10-007.


Which of the following options would you choose if you want to control the amount of broadcast traffic on a network in order to allow different segments to communicate with each other?
- A. Add a layer 3 switch and create a VLAN.
-
Correct!
- B. Add a bridge between two switches.
-
Incorrect.
- C. Add a router and enable OSPF.
-
Incorrect.
- D. Add a firewall and implement proper ACL.
-
Incorrect.
A network is installed but it is failing redundancy testing at the MDF. The traffic transported is witnessed to be a mixture of both multicast and unicast signals. Disruption of service is causing rerouting. Choose from the following options what can BEST handle situation.
- A. Layer 2 switch
-
Incorrect.
- B. Proxy server
-
Incorrect.
- C. Smart hub
-
Incorrect.
- D. Layer 3 switch
-
Correct!
For a specific few servers to always receive same addresses, it is required to set aside addresses in a DHCP pool. Which of the following options do you think must be configured?
If you are a network technician setting up a DHCP server on a LAN segment. You want to allow the hosts on the LAN segment to be able to access both the internet and the internal company servers. The hosts are using dynamic IP addresses. Which of the following options would you configure in the DHCP scope? (opt three).
- A. Reservations
-
Incorrect.
- B. Default gateway
-
Correct!
- C. DNS servers
-
Correct!
- D. Subnet mask
-
Correct!
You are a technician completing an external website and finishing the setup of access rules in the firewall. Upon testing it is discovered that the site can only be reached by users outside the internal network. The website responds to a ping from the internal network and resolves the proper public address. Which of the following could the technician do to fix this issue while causing internal users to route to the website using an internal address?
- A. Configure NAT on the firewall
-
Incorrect.
- B. Implement a split horizon DNS
-
Correct!
- C. Place the server in the DMZ
-
Incorrect.
- D. Adjust the proper internal ACL
-
Incorrect.
A new server was being configured. You being a technician request an MX record to be created in DNS for that server. However, it is noticed that the record was not entered properly. From the following options, choose one that was MOST likely installed requiring an MX record to function properly.
- A. FTP server
-
Incorrect.
- B. Firewall DMZ
-
Incorrect.
- C. Load balancer
-
Incorrect.
- D. Mail server
-
Correct!
Identify a protocol that forwards traffic using label-switching routers and label-edge routers.
You are using POTS line to connect a computer to an ISP. Which of the following is MOST like to use an RJ-II connector to connect the computer?
- A. Analog modem
-
Correct!
- B. DOCSIS modem
-
Incorrect.
- C. Multilayer switch
-
Incorrect.
- D. Access point
-
Incorrect.
There is an unused cable, terminated with a DB-9 connector. Out of the following, which protocol was MOST likely used on this cable?
Following are some connection types. If you want to terminate DS3 connections in a telecommunications facility, which connection type will you use?
Following are some types of cabling. Identify which of these types can an F-connector be used on?
If you are a network technician and want to uplink a new networking device, you should use multimode fiber. Identify which of these Ethernet standards could you utilize? (opt two).
As a network engineer you want to set up a topology. You do not want that topology to fail if there is an outage on a single piece of the topology. However, to avoid congestions computers need to wait to talk on the network. Which of these topologies would you implement?
Following are some network topologies. Which of these utilizes a central device and gives point-to-point connections to all other devices?
Following are network topologies. Which of these has a central, single point of failure?
- Home
- Practice Exam - CompTIA Network+
Practice Exam - CompTIA Network+
More Information:
- Learning Style: On Demand
- Learning Style: Practice Exam
- Difficulty: Beginner
- Course Duration: 1 Hour
- Course Info: Download PDF
- Certificate: See Sample
Contact a Learning Consultant
Need Training for 5 or More People?
Customized to your team's need:
- Annual Subscriptions
- Private Training
- Flexible Pricing
- Enterprise LMS
- Dedicated Customer Success Manager
Outline
Reviews
Community Experts

About Our Experts
Our experts featured on QuickStart are driven by our ExpertConnect platform, a community of professionals focused on IT topics and discussions. Interact with these experts, create project opportunities, gain help and insights on questions you may have, and more.