A tablet, in order to transmit at the required speed, needs an SNR of 25 dB while the noise floor is -95 dBm in the current RF environment cell. What should the RSSI edge be to meet the necessitated SNR?

To create a larger wireless cell, the customer needs the signal strength of 6 dB and currently 4mw is being transmitted by an access point. What should the new transmit power be?

The wireless networking is being designed by a wireless engineer for a company with offices located at two different places. To find the maximum EIRP allowed which two regulatory bodies should they check? (Choose two.)

When Cisco 5508 Wireless Controller is installedusing default settings, how often do the RRM update occur?

A request for a single point of policy enforcement for LAN and WLAN has been made by the customer. Which deployment model willyou use?

A request has been made by the customer for the proper port configuration to allow for LAG on a Cisco 2504 Wireless Controller to a Cisco IOS switch. Which EtherChannel mode will be used on the switch in order to allow for the WLC to connect?

The wireless equipment is to be administered as securely as possible for the customer. Whichthree management protocols can truly provide encrypted access to the equipment? (Choose three.)

The two destination ports that must be open to deploy a Cisco Cloud Wireless Infrastructure are? (Choose two.)

A remote packet capture on the wireless network is being performed by a help desk engineer. The necessary access point to perform this function are?

The FUS is to be upgraded on the Wireless LAN controller by an engineer. How can the upgrade status be monitored?

When a wireless site survey was being conducted, the signal strength dropped dramatically, when outside of the room containing the access point. The building that is being surveyed is made of wood and drywall. Which wireless anomaly does it represent?

A wireless engineer is requested to design a deployment covering the walkways of a stockroom with optimal coverage while bleeding RF across aisles. Which antenna type provides the desired coverage?

A ticket help desk states that a wireless access point is not joining its controller and is flashing at high speed. How can the help desk orchestrate the access point using default settings?

After you configure the Cisco 5508 Wireless Controller v7.6, a customer has asked for an SSID that permits for client web authentication through email. What kind of authentication method will be used?

When deploying a wireless network through a lush area, which two principles should be kept in regard? (Choose two.)

The interferer in Cisco CIeanAirthat an engineer may see is?

A network engineer realizes that there is a problem in communication between two mesh APs. After examining radio configurations, it is found that one of the AP is transmitting at 60mW while the other one is transmitting at 3 mW. The decibels needed by the3-mW AP to match the 60-mW AP are?

An antenna is required by the network engineer for a point-to-point bridge with a minimum of 20 dBi of gain. The antenna appropriate for the current task is?

An engineer is asked to find out the maximum EIRP allowed for the office situated in Asia. The regulatory body responsible for that is?

A wireless engineer in the United States have an access point using the 5.725-GHz channel. The band AP is operating in is?

The RRM feature that permits an access point to avoid a non-IEEE 802.11interference is?

For the combination of the signals fromradio chains andnumerous antennas to improve SNR which IEEE 802.11n client feature will be used?

An engineer’s minimumrequirement for an AP is four receivers, two spatial streams, and three transmitters. The device that fulfill these requirements is?

What option would be best to use in order to form the BSSID in a BSS?

An easy maintenance wireless deployment is required by a network engineer at a retail storethat is also verified for PCI compliance. The solution that requires the least work to meet the current need is?

The two access points that would meet the customers’ requirement for deploying the Cisco Cloud Wireless architecture with 802.11ac capabilities are? (Choose two.)